Philips WelcomeEye Connect 2 - Intercom Panel Installation

EN8
WelcomeEye Connect 2 / Touch / V1
4. Installation of the main or additional intercom panel*
Note: The product must not be connected to the power supply before the wiring has been
completed.
DES 9900 VDP
5 1 0 0 6 3
1
2
3
4
5
6
1 2
7
8
1
2
1
2
DES 9901 VDP
5 1 0 0 6 3
Made in P.R.C
IP44
20V 110mA
RFID 125kHz
1m60
1
1
2
2
1 2
4
7
5
3
6
8 9
Avidsen
19 avenue Marcel Dassault
37200 TOURS
FRANCE
1 - Remove the tamper-resistant screw from the intercom panel.
2 - Tip the intercom panel cover forward.
3 – The intercom’s lens should be approximately 1.60m above the ground.
4 – Mark the locations.
5 - Drill.
6 - Use pegs adapted to the nature of the support (the screws supplied are suitable for
solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike
plate and the gate (see section 1. Wiring). Congure the switches at the back of the
intercom panel (see section 2. Conguring the intercom).
8 – Insert the screws and ret the two caps concealing the retaining screws.
Note: screw through the black covers on the back of the intercom panel without removing them.