After usage
8482_en_03 PHOENIX CONTACT 143
11.3 Device defect and repair
Repairs may only be carried out by Phoenix Contact.
• Send defective devices back to Phoenix Contact for repairs or to receive a replacement
device.
• We strongly recommend using the original packaging to return equipment.
• Include a note on the packaging indicating that the contents are returned goods.
• If the original packaging is no longer available, observe the following points:
– Observe the humidity specifications and the temperature range specified for trans-
port (see Section "Technical data" on page 144).
– If necessary, use dehumidifying agents.
– Use appropriate ESD packaging to protect components that are sensitive to elec-
trostatic discharge.
– Secure any loose parts.
– Make sure that the packaging you select is large enough and sufficiently thick.
– Only use plastic bubble wrap sheets as wadding.
– Attach warnings to the transport packaging so that they are clearly visible.
– Please be aware that the delivery note is to be placed inside the package in the
case of packages that are to remain within the same country. However, if the pack-
age is being sent abroad, the delivery note must be placed inside a delivery note
pocket and attached to the outside so that it is clearly visible.
11.4 Disposal
Controller disposal • Do not dispose of the device with household waste; it should instead be disposed of in
accordance with the currently applicable national regulations.
Packaging disposal • Dispose of packaging materials that are no longer needed (cardboard packaging, pa-
per, bubble wrap sheets, etc.) with household waste in accordance with the currently
applicable national regulations.
To Next Page
Loading...
Need help?
General
