8482_en_03 PHOENIX CONTACT 154
B Appendix for document lists
B 1 List of figures
Section 3
Figure 3-1: Components of the controller ..............................................................16
Figure 3-2: Axioline F station with AXC 1050 controller .........................................19
Figure 3-3: PROFINET controller with the AXC 1050 as an example ....................20
Figure 3-4: PROFINET device using the AXC 1050 as an example ......................21
Figure 3-5: Redundant higher-level control system and lower-level network
ring redundancy using MRP ................................................................22
Figure 3-6: Connection and operating elements of the controller
(AXC 1050 and AXC 1050 XC) ...........................................................24
Figure 3-7: Diagnostics and status indicators .......................................................25
Figure 3-8: Mode selector switch ..........................................................................29
Figure 3-9: Reset button (1, concealed) ................................................................30
Figure 3-10: Internal basic circuit diagram (AXC 1050 (XC)) ...................................32
Figure 3-11: Communication paths: (1) Ethernet, (2) service interface
(Micro-USB type B) .............................................................................33
Figure 3-12: Ethernet interface and pin assignment ................................................34
Figure 3-13: Service interface .................................................................................35
Figure 3-14: Terminal points for the supply voltage (communications power U
L
) ....36
Figure 3-15: Structure of the bus base module of the controller ..............................36
Section 4
Figure 4-1: Placing the module vertically .............................................................37
Figure 4-2: Horizontal (A) and vertical (B) mounting position ................................39
Figure 4-3: Structure of an Axioline F station with AXC 1050 controller ................40
Figure 4-4: Mounting the bus base modules .........................................................41
Figure 4-5: Snapping on the controller ..................................................................41
Figure 4-6: Inserting the SD card ..........................................................................42
Section 5
Figure 5-1: Overload range with fall-back characteristic curve .............................43
Figure 5-2: Overload range without fall-back characteristic curve .......................43
Figure 5-3: Connecting a solid cable .....................................................................44
To Next Page
Loading...
Need help?
General
