Description of the AXC 1050 (XC)
8482_de_03 PHOENIX CONTACT 31
3.8 Parameterization memory
The parameterization memory can be used to save programs and configurations (e.g.,
WebVisit projects, IP address of the controller, etc.) which belong to your PC Worx project.
In addition, application-specific data can also be stored in the parameterization memory
(see Section 7.3).
The controller has an integrated parameterization memory. Alternatively, it is possible to
use a pluggable parameterization memory in the form of an SD card. The SD card is optional
and not required to operate the controller.
NOTE: Potential data loss
If you remove the SD card during operation, this may result in a loss of data.
• Do not remove the SD card during operation.
NOTE: Damaging the SD card after formatting
The SD card is already formatted and is intended for use with Phoenix Contact devices.
When you format the SD card, certain information on the SD card that is required for use
with Phoenix Contact devices is lost. After formatting, you can no longer use the SD card
to operate the controller.
• Make sure that the SD card is not formatted.
The SD card is recognized during initialization of the controller.
• Make sure that the SD card has been inserted before switching on the controller to
enable the controller to use it.
• Only insert and remove the SD card when the controller supply voltage is disconnect-
ed.
• Only use an SD card provided by Phoenix Contact (for ordering data, see Section
"Accessories" on page 148).
For additional information on the parameterization memory, please refer to Section 7.3.
To Next Page
Loading...
Need help?
General
