RFC 4072S
184 / 272
PHOENIX CONTACT 108580_en_02
F_ADDR_XXXXX_ACK_REQ *) BOOL F-Device XXXXX requires an operator acknowledge request after
removing an error. Possible reasons for activating the operator
acknowledge request:
– Communication error (CRC, F_WD_TIME_OUT)
– Error in an F-Device. Please refer to the user documentation for
the F-Devices used.
F_ADDR_XXXXX_ACK_REI *) BOOL If F-Device XXXXX requires an operator acknowledge request, it can
be acknowledged by an operator acknowledge reintegration (F_AD-
DR_XXXXX_ACK_REI).
F_ADDR_XXXXX_DEVICE_FAULT *) BOOL Error in an F-Device.
If this variable was set to TRUE during operation, the cause of the error
must be removed first so that acknowledgment can be carried out
using the F_ADDR_XXXXX_ACK_REI or ACK_REI_GLOBAL vari-
able. If the cause has been removed, the F_ADDR_XXXXX_DEVICE
FAULT variable is set to FALSE again.
Table 8-6 Management/diagnostic variables for each configured F-Device
System variable Ty pe Meaning
For information on which errors cause the used F-Device
to control this variable, please refer to the device-specific
user documentation.
To Next Page
Loading...
Need help?
General
