Startup and validation
108580_en_02 PHOENIX CONTACT 87 / 272
Switch on the power supply to the device.
Carry out the validation using the checklist ““Initial startup”
and “restart/device replacement” validation” on page 253.
Section “Appendix: checklists” on page 243
Table 4-2 Steps for restarting the RFC 4072S
Step Relevant section and literature
WARNING:
Take appropriate measures to ensure that your
system/machine does not present any danger
during startup and validation.
WARNING:
The planned system/machine safety function is
only available after the appropriate measures
have been taken, which are specified in the vali-
dation plan of the machine/system for replacing
the RFC 4072S.
Please note that the RFC 4072S requires approximately two minutes to start up. This is due to the comprehen-
sive selftests the device must perform. The status is indicated on the display.
Please note:
– If a parameterization memory from the old device is used, which contains the configuration created for your
application, only carry out the safety-related steps.
– If a parameterization memory with a valid project is not available, perform the steps for initial startup in this
case.
WARNING: Safety-related steps
The following step includes the safety validation of the PROFIsafe system.
For the following step, please also observe the checklists in Section C, “Appendix: checklists”.
WARNING: Carry out verification in accordance with safety standards
Carry out verification for all the steps involved in creating the safety program for your application in accordance
with the applicable safety standards for your application.
To Next Page
Loading...
Need help?
General
