The mould should point away
from the hearing aid as shown
in the picture.
Remember that the mould should
face away from the hearing aid
and not towards it as shown in
the picture.
Alternatively, using a sharp knife
can create a closer cut. Place the
mould down on a hard surface if
using a knife.
Use the old piece of tube as a
measure for the new piece.
Push the end of the hearing aid
hook rmly inside the new piece
of tubing.
If the hearing aid is loose over the top of the ear, try shortening
the tube a little as the old piece may have stretched upon removal.
If the old piece of tube has been lost or damaged, place the
mould in the ear and the hearing aid behind. Ask someone to
mark with a pen where the two meet.
Remember to allow a little extra as the tube pushes over the
end of the hearing aid.
1312
To Next Page
Loading...
Need help?
General
