Pilot-1 Aeronca Champ - Page 11

11
25. Locate the Rudder pull-pull and control horn
bag.
26. Cut the rudder pull-pull cable into two (2)
pieces. Then install rudder pull-pull cable as
shown and crimp with pliers.
27. Install the rudder servo and pull leads thru
fuselage with small piece of music wire or
straightened coat hanger wire. Use tape to
hold cables at aft end of fuselage.
28. Install Elevator CA hinges using the same
technique as the ailerons. Trial fit then use
2-3 drops thin CA per hinge per side.