Pilz PSEN sc ME 5.5 08-17 - Page 36

Project configuration
Operating Manual PSEN sc ME 5.5 08-17
1005388-EN-01
| 36
Monitoring of reference outlines is used to detect any changes or changes to the environ-
ment of the safety laser scanner.
} Changes to the installation position of the safety laser scanner due to vibration
} Changes of the safety laser scanner due to manipulation
} Changes of an additional protective equipment
Applications of a reference outline for protecting moveable constructions
When the reference points are set to the position of a moveable construction, for example a
door, the safety laser scanner switches the OSSDs to the OFF state when the position of
the door changes.
[2]
[1]
[4] [4]
[3]
[4]
[5]
Fig.: Using a reference outline for protecting a moveable construction
Legend
[1] Danger zone
[2] Area covered by the safety laser scanner
[3] Safety laser scanner
[4] Reference points
[5] Moveable construction that is protected by the reference points