Pilz PSEN sc ME 5.5 08-17 - Connection to Psenscan Configurator

Wiring
Operating Manual PSEN sc ME 5.5 08-17
1005388-EN-01
| 60
[1]
[2]
[3]
Legend
[1] Protective membrane
[2] Memory module
[3] Cable with connector
5. Remove the label [1] from the memory module and insert the memory module at the
safety laser scanner.
6. Fix the screw of the memory module with a torque of 1 Nm.
7. Place the protective cover at the safety laser scanner and screw the protective covers
with 1 Nm.
6.8 Connection to PSENscan Configurator
Please note:
} Ensure that the software PSENscan Configurator is installed on the configuration PC.
We recommend that you always use the latest version (download from www.pilz.com)
} Ensure that the safety laser scanner is switched off when creating a connection to the
configuration PC.
100BaseTX cable
Bit rate 100 MBit/s
Max. segment length 100 m
Medium STP
(shielded twisted pair)
*1
2 pairs
Category 5
*2
Connection 4-pin M12 male connector /4-pin RJ45 male
connector
Topology Point-to-point/hub
(hub, switch)