Pima HUNTER-PRO 32 RXN-9/416 - USER MENU DISPLAY; Fault LED Indications

HUNTER-PRO 32 User Manual LED Keypads
7
The corresponding fault LED will light as described in the following table:
LED No.
Indication
Fault Description Keypad
1 BATTERY
*
Low battery RXN-9/416
2 AC
*
No voltage from mains RXN-9/416
3 PHONE
*
No communication with monitoring station
or, a problem with telephone line
RXN-9/416
4 DC
*
Low voltage RXN-9/416
5 ZONE
*
Fault zone RXN-9/416
6 CLOCK Hour and/or date are not set RXN-9/416
7 TAMPER
*
Open tamper RXN-9/416
8 FUSE
*
Detector’s voltage is short RXN-9/416
9 BELL
*
External/Internal Bell fault RXN-9/416
10 I/O-W
*
A problem with the wireless receiver RXN-416
11 I/O-8
*
A problem with one of the remote expanders RXN-416
12 KEYPAD
*
A problem with one of the system keypads RXN-416
* These faults should be fixed by a qualified technician/installer
Programming/connection error: The
keypad ID should be reprogrammed
Numerical LEDs are flashing
left-to-right
RXN-9/416
Programming/connection error: The
keypad is disconnected from the panel
Numerical LEDs are flashing
right-to-left
RXN-9/416
User Menu Display
Accessing User Menu – by entering Master Code, Enabled User Code, or long press
on
and User Code (see System Access Codes on page 8) – turns ON the
ARMED and FAULT LEDs.
Pressing a programming menu key (see below table) will turn ON the
corresponding LED number (the key itself on the RXN-9 and the LED number in
the keypads panel on the RXN-416).
Key After entering
Master/User Code
(short press)
Secondary
Function
(long press)
LED Indication Keypad
Temporary bypass of zones
-
Numerical LED 3
constantly ON
RXN-9/416
Programming telephone
numbers
-
Numerical LED 6
constantly ON
RXN-9/416