HUNTER-PRO 32 Intruder Alarm System - Installation Manual
28
TAMPER
Zone
10K ¼W
PIR (NO)
(-)
13K ¼W
+-
JP2
JP1
PIR1
TAMPER NC RELAY NO
Common
13K ¼W
10K ¼W
Zone
2 EOL resistor with a NO
output
2 EOL resistors connected to a TAMPER in
serial connection to a NO output
3.3 Connecting Zone-Expenders (General)
It is possible to expand HUNTER-PRO 32’s zones and outputs by using different
expansion cards and Add-On devices.
The following is a brief scan of the zone and outputs expansion options. A
detailed installation description is found later on (check the section reference at
the end of each expansion option.)
Zone numeration in HUNTER-PRO 32 is dynamic. However, there is a set
priority as to the zones’ chronological order. See table 1.
IMPORTANT!
Remember HUNTER-PRO 32 supports up to 32 zones, even if the expansion
cards have more than 32 zones.
Expansion Option Zone number allocated by system
Control Panel 8-1 8-1 8-1 8-1 8-1 1-8
EXP-LOCAL 16-9
)2( )2( )2( )2(
I/O-8-External Expender 1 24-17 24-17 16-9 16-9 16-9
)2(
I/O-8-External Expender 2 32-25 32-25 24-17 24-17
)2( )2(
To Next Page
Loading...
