HUNTER-PRO 32 Intruder Alarm System - Installation Manual
32
Along with the RC-PRO the HUNTER-PRO 32 becomes a Hybrid system that
supports both wired and wireless detectors.
To connect the RC-PRO:
Use the Communication Cable to connect the control panel to the serial output.
Follow Drawing 6 and Table 3).
In Out
Control
Audio
SE RAL
DIP
345678
TAMPER
GND 12VIN OUT
RC-PRO
HUNTER-PRO 32
Drawing 6-Connecting RC-PRO to control panel
Wire color
RC-PRO
Red 12V
Black GND
Green OUT
White IN
Table 3-Connecting RC-PRO
3.4 Connecting Key/Remote Control
Connect the key or remote control receiver according to the diagram below
with a 10kW EOL resistor on the PCB terminal input. The key can be
momentary or ON/OFF switches. The default is connection to momentary key.
NOTE:
Make sure momentary key is programmed when connecting remote control.
To Next Page
Loading...
