HUNTER-PRO 32 Intruder Alarm System - Installation Manual
45
Connect AC mains power supply.
Connect the backup battery to the fast connection terminals, red wire
to (+) and black wire to (-).
IMPORTANT!
Failing to connect the cables as described will permanently damage the control
panel!
NOTE:
If you connect the battery before the Mains (AC), an AC FAULT will be
displayed until you connect the AC. The AC FAULT will be logged in memory.
Close the control panel case and verify that the screws do not touch
the battery.
1 JAN 04 00:00
Clock not set
Drawing 6-HUNTER-PRO 32
System Display
When connecting the voltage (AC or battery) a buzz
is extracted from the keypad, and the display shows
the keypad’s type, version, and ID. After a few
seconds the regular display returns (see drawing 6).
Then, the Fault LED blinks, and a message that the
clock is not set.
After all faults are handled, the red LED ceases to blink and the Default Display
disappears.
3.18.1 Setting Time:
USER MENU
Choose 1,2...
8
USER/MASTER CODE
9
Enter time (HH:MM format) and
9
Enter Full Date
and then press
and then
To Next Page
Loading...
