Pima Hunter-Pro 32 - Chapter4 Operating & Programming the System; General; Programming Possibilities; Programming with the Fast Programmer PRG-22

HUNTER-PRO 32 Intruder Alarm System - Installation Manual
47
C HAPTER 4
O
PERATING &
P
ROGRAMMING
THE
S YSTEM
4.1 General
The HUNTER-PRO 32 is supplied with factory default parameters. In most
installations you will have none or a few parameters to program, except for
user-specific parameters such as telephone numbers, zone names etc.
4.2 Programming Possibilities
There are four different ways to program the HUNTER-PRO 32:
 Fast Local-Uploading with the PIMA Fast Programmer PRG–22. The
PRG-22 connects to any LCD keypads
 Local Up/Download with a PC, LCL–11A PC interface, and COMAX
software
 Remote Up/Download over the telephone line with a PC, modem, and
dedicated COMAX software from PIMA
 Manual programming with LCD keypad
4.2.1 Programming with the Fast Programmer
PRG-22
This type of programming can be done only via the installer menu and an LCD
Keypad. Connect the PRG-22 to the designated connector according to the
following drawing. In RXN-400/410 LCD keypad models the RJ-22 connector is
internal, on the PCB’s upper left side. Refer to section. 5.9.3 for fast programming
procedures.