Pima Hunter-Pro 32 - Modem Call Back; Communication Features; Number of Rings

HUNTER-PRO 32 Intruder Alarm System - Installation Manual
66
Raddio Rep. Codes
ENTER/NEXT/ENF
Z1 :FF Z2:FF
Z3: FF Z4:FF
ENTR
ENTR
Press to move to the next report codes
In these screens the Report Codes to the different Radio Formatted events is
programmed.
Each of the code’s digits can receive the value “0” to “15”. Values “10” to “15”
are represented by the letters “A” to “F” respectively, thus:
 A=10
 B=11
 C=12
 D=13
 E=14
 F=15
Changing a Report Code:
 Enter the screen of the event you want to change by pressing
 Place the cursor on the event’s digit by using
and
To enter digits/letters representing digits:
 Use keypad keys in order to choose a digit from “0” to “9”
 Press the
key as many times as needed in order to choose a
letter between “A” and “F”
5.4.3 Modem Call Back
3
ENTR ENTR
NEXT
Communication
ENTER/NEXT/END
Modem Call back
ENTER/NEXT/END
9
In this screen you program up to 3 telephone numbers that re-call the modem.
It is another safety measure that allows only the installer with COMAX software
to enter the alarm system (in order to reconfigure parameters).
5.4.4 Communication Features
3
ENTR ENTRNEXT
X2
Communication
ENTER/NEXT/END
Commun. Options
ENTER/NEXT/END
9
In these screens you program the system’s communication features (telephone
line, automatic test, wake-up test).
5.4.4.1 Number of Rings