HUNTER-PRO 32 Intruder Alarm System - Installation Manual
74
NOTE:
To navigate on bar, use and keys.
Marking a “+” under a parameter’s letter enables this parameter. Marking a
“-” denies this possibility.
In order to change the mark from “-“ to “+” (and vise versa) use
Par. Para. Full name Note
A
ON/OFF follows arming (+) In ON/OFF output, there will be “-“ in
GND.
(-) GND is not “-“ in ON/OFF
B
Buzzer (+) Alarm output will be activated when
buzzer is activated
S
Siren (+) Keypad buzzer will be activated
simultaneously with siren.
F
Fast arming
(+) Pressing and holding the
key, will
fully arm the system. Press and hold the
key will arm the system in HOME 1
state. Press and hold
key will activate
HOME 2 state.
1
Bypass HOME1 delay (+) Enabled
2
Bypass HOME2 delay (+) Enabled
Z
Present alarms in ON (+) The system will present the zones that
triggered the alarm when it was ON.
NOTE:
Each time the cursor in the screen stands on a certain parameter,
automatically a description of this parameter appears for 3 seconds.
5.7 System Responses
In these screens the system responses to special events are programmed (such
as faults, false code, etc.) when the system is ON and OFF.
To Next Page
Loading...
