HUNTER-PRO Series Installation Guide 27
3.2.6 I/O-WN
I/O-WN is a wireless receiver that integrates with
HUNTER-PRO Series. It enables the connection of
wireless detectors (such as PIR, Reed Switch etc).
See section 3.2 for more details.
I/O-WN connects to the PCB’s KEYPAD connections. See
the next drawing and the table that follows.
I/O-WN Control Panel
1 -V -
2 +V +
3 OUT IN
4 IN OUT
Figure 23. I/O-WN wiring
For further information regarding the I/O-WN, refer to its
installation guide
3.2.6.1 I/O-WN LEDs
The I/O-WN has 5 LEDs, described in the following table:
LED Description Status
ON Card is operating and connected to voltage
OFF Fault in the connection to voltage
RUN
(Green)
I/O-WN operation and
connection to voltage
Flashes Fault in card voltage
ON Communication fault
OFF Short in communication wiring
DATA
(Red)
I/O-WN connection to
control panel
Flashes Data connection is OK
Flashes The card is receiving transmission from a
wireless device
RX
(Red)
Receiving transmission
OFF No transmission is received from any
wireless device
To Next Page
Loading...
