HUNTER-PRO Series Installation Guide 41
Display Fault
5 JUN 07 14 :20
FL: Zone 14
Tamper open in zone #14
5 JUN 07 14 :25
LB: Zone 19
Low Battery in zone #19
7 OCT 07 16 :32
SV: Zone 35
No supervision signal from zone #35
W/L Re cvr. fail
ENTER/ NEXT/ END
This fault appears when trying to program the
I/O-WN although the receiver is not installed
3.18.3 Memory Log of Faults
Show:
All Events-0
9
User Menu
Select 1,2...
MASTER/USER
CODE
2
NEX T
Show:
Defaults Only-1
NEXT
Show:
Zone Alarms-2
NE X T
Show:
Arming/Dis.-3
The memory log has 3 viewing options: 1 - all events, 2- alarms, 3 - arming/disarming.
The top line displays the memory event number (top left) and the time and date in
which the event was registered. The event name is displayed in the bottom line.
3.18.3.1 Examples for faults as displayed in the memory
log:
Memory Log Fault
1) 5 JU N 07 14 :20
W/L R ecv r. f ail
This fault appears when trying to program the
I/O-WN although the receiver is not installed
2) 5 JU N 07 14 :20
Wireless Z F aul t
Wireless detector’s tamper switch is open. The
zone name and number are displayed intermittently
3) 5 JU N 07 14 :20
Low B att er y - 15
Low battery in zone #15 (wireless detector)
4) 5 JU N 07 14 :20
Supervision - 2 8
Supervision fault in zone #28. The zone’s name
and number are displayed intermittently
5) 5 JU N 07 14 :20
W/L Unit Tamper
I/O-WN receiver tamper fault
6) 5 JU N 07 14 :20
Receiver J amm.
I/O-WN receiver jamming fault
To Next Page
Loading...
