42 HUNTER-PRO Series Installation Guide
CH. 4. PROGRAMMING BASICS
The HUNTER-PRO series is supplied with factory default parameters. In most
installations you will have none or few parameters to program, except for user-specific
parameters, such as telephone numbers, zone names etc.
There are 3 ways to program the HUNTER-PRO series:
1. Locally with the PIMA Fast Programmer PRG–896. The PRG-896 can have 4/7
different presets. It connects to any LCD keypad.
2. Locally or remotely (via telephone or GSM DATA channel) using COMAX
3. Using the LCD keypad
4.1.1 Fast Programming with PRG-896
PRG-896 is based on ROM chip. It holds parameters that have been uploaded with
COMAX and then downloaded to a system at a site. PRG-896 can only be programmed
with an RXN LCD Keypads. It connects to RJ-11 connector on the keypad PCB. See the
fast programming procedures on section 5.10.3.
Figure 40. Connecting PRG-896 to the LCD Keypad
To Next Page
Loading...
