56 HUNTER-PRO Series Installation Guide
5.5.3 The MS Telephone Numbers
EN TR NEXT
ENTR ENTR
Communication
ENTER/NEXT/END
Phone Numbers
ENTER/NEXT/END
MS Ph o ne 1<Del=# MS Phone 4<Del=#
X23
….
Set MS1 telephone numbers (4 max.). If the system reports to 2 MSs (double report),
telephones #1 & #2 are allocated to MS1, and #3 & #4 to MS2. Press [ENTR].
When the MS does not answer a call from telephone #1, the
system tries to dial the other numbers. The system performs up to
8 dialing attempts in all
5.5.4 Communication Options
3 ENTR ENTRNEXT
X3
Communication
ENTER/NEXT/END
Commun. Options
ENTER/NEXT/EN D
P TL LTA VD RP OSD
+ -- -+- -- +- +--
Par. Description Setting to ‘+’ means…
P Connected T.Line A telephone line is connected to the system
T No Dia. tone chck The system dials without checking for a dial tone (in case
the system connected via switch-board or the line is not
clear)
L Line Test in ON The system tests the phone line once a minute when it is
armed
L Line Test in OFF The system tests the phone line once a minute when it is
disarmed
T Tone Dial “+” For tone (DTMF)
“-“ For Pulse
A Answer. Machine If answering or fax machine are connected to the phone
line, the system snaps incomin
a sequence of
two rings, hang-up, 10 seconds pause and a ring
Set the answering machine to pick calls
after more than 2 rings
V Voice Unit VU-20 voice unit is connected to the system
D Download Disable Downloading parameters remotely using COMAX is disabled
(default). To enable it, the user must enter Master code and
press [ENTR] twice (The Comax must dial the system within
2 minutes or it will be reset to ‘+’ [disabled])
R Rem. Disarm
Disab
Remote disarming by the telephone is disabled
To Next Page
Loading...
