82 HUNTER-PRO Series Installation Guide
6.1.1 Example for Mode A
Arming the system via telephone: Dial the system’s phone no. The system answers
wait for the confirmation tone to end Enter Main code Wait for command
confirmation tone to end Press [1]
6.2 Mode B
1. Repeat steps 1-4 in Mode A to contact the system.
2. To trigger an output, press [*] and the corresponding command from the following
tables.
3. To deactivate an output,
press [#] and the corresponding command from the
following tables.
General Commands PCB Outputs OUT-1000
Pres
s
Command Press Command Press Output
*
00 Turn off the external siren and
stop dialer
11 Ext. SIREN 21 #1
*
01 Arm the system 12 Int. SIREN 22 #2
#01 Disarm the system 13 RELAY 23 #3
*
04 Arm to ‘Home 1’ 14 SMOKE 24 #4
*
07 Arm to ‘Home 2’ 15 ON/OFF 25 #5
*
08 Start listening-in
16 ALARM
26 #6
17 Audio Ctrl 27 #7
28 #8
Relays on I/O-8N Expanders
Press I/O-8N Press I/O-8N Press I/O-8N
31 #1 37 #7 43 #13
32 #2 38 #8 44 #14
33 #3 39 #9 45 #15
34 #4 40 #10 46 #16
35 #5 41 #11
36 #6 42 #12
To Next Page
Loading...
