HUNTER-PRO Series Installation Guide 85
Fault Description & Repair
Mains Fault No mains power. If other appliances around are on, check the
system’s electric socket and fuse. If ok connect mains and the
PCB AC fuse
TAMPER 1 Tamper 1 is open
TAMPER 2 Tamper 2 is open
Zone Fault 1. In EOL protected zones: F - Cut, S - Short
2. In detectors wires: F L- Cut, S H- - Short
3. In wireless detectors: detector’s tamper is open
KEYPAD NOT
CONNECTED
No communication between the keypad and the PCB. Check the
following:
1. Disconnection between PCB’s “OUT” and keypad.
2. Keypad’s volta
e supply is lower than 13v. (verify that no more
than 8 keypads are connected)
3. Keypad fault - replace it.
4. PCB fault - replace it.
Phone Line Fault The system does not indicate any dial tone. The system checks
the phone line constantly.
To manually test the phone line, disconnect
any appliance connected to it
Keypad X Fault 1. Check keypad X ID (if possible)
2. Check keypad X wiring
3. If ID and wiring is OK, disconnect the keypad and connect it as
close as possible (50 cm max.) to the system box. If the keypad
still out-of-order, consult PIMA support
Detec. Vol. Fault Check for short in the detectors’ wires
Expander X Fault Expander’s X comm. or vol. connection fault
Expander X Tamper Expander’s X tamper is open
Keypad X Tamper Keypad’s X tamper is open
Other Keypad in use When more than one keypad is connected and one is being
programmed, the others will have this message on screen. This
message appears also when the system is being programmed
from a different source such as remote programming via
computer and telephone.
GSM-200 faults
GSM Unit Fault Connection problem or fault in GSM-200 receiver
GSM Comm. Fault GSM-200 to MS1 connection problem
GSM Link Fault Low reception or jamming in GSM channel
SIM Card Fault No SIM card installed in GSM-200 or SIM card fault
GSM Com. Fault 2 GSM-200 to MS2 connection problem
For further information on GSM-200 refer to the GSM-200 guide
To Next Page
Loading...
