PIMAX Crystal Light - Page 16

©
2024 Pimax All Rights Reserved
14
5. How to Clean and Care for Your
Pimax Headset
5.1. Cleaning and Caring for the Facial
Foam Interface
Using a clean alcohol wipe or a clean microber cloth dipped in a small amount of 75% alcohol
solution, gently wipe the surface and surrounding areas in contact with the skin until the surface is
slightly wet. Allow to dry for 5 minutes or until completely dry before use.
CAUTION READ CAREFULLY
The foam facial interface will begin to exhibit signs of wear and tear after repeated cleaning
and disinfection. Hand washing or machine washing is not recommended as it will accelerate
the wear and tear. It is recommended to replace the foam occasionally as appropriate
Leather PU foam: discoloration, stickiness on the surface, and reduced comfort on the face
Cloth foam: discoloration, surface fuzzing, texture softening, glasses wearing users may have
an increased chance of contact with the HMD lenses.
5.2. Lens care
During use or storage, please be careful and prevent hard objects from touching the lenses. Hard
objects may damage the lenses
Use a clean microber cloth, like those used to clean eyeglasses, to gently clean the lenses with a
small amount of clean water or dry. Do not rub the lenses in a circular motion. Starting from the
center of the lenses push the cloth out to the edge of the lenses to reduce the risk of scratches.
CAUTION READ CAREFULLY
Do not use alcohol to clean the lenses, as it may cause damage to the lens coatings.