22
Troubleshooting (Error message display)
Error message display
When the unit is unable to operate properly, an error code is displayed on the display panel. Check the error code displayed against the
following table and take the recommended action to correct the error. If an error code other than any of the error codes listed in the
table below is displayed or if the same error code is displayed even after corrective action has been taken, contact your nearest Pioneer
Service Station or contact the store from which you purchased your player for assistance.
Error code
E–72 01
E–83 01
E–83 02
E–83 03
E-83 04
E-83 05
E–91 01
Error type
TOC READ ERROR
PLAYER ERROR
MP3 DECODER ERROR
DATA FORMAT ERROR
MECHANICAL TIME OUT
Error content
Can’t read TOC data.
Can’t play this disc properly.
Can’t play this disc properly.
Mechanical operation did not end within
specified time.
Cause and remedy
Disc is cracked.
= Replace disc.
Disc is dirty.
= Clean disc.
If other discs operate normally, problem is with
this disc.
Does not conform to MP3 format.
= Change to disc conforming to MP3 format.
Foreign object in disc loading slot.
= Remove foreign object.
To Next Page
Loading...
