15
En
Install Your Flat Panel Display
02
English
2.3 Check the Location for Suitability
When choosing the location for your panel, there are several factors to keep in mind. The installation site should
be out of direct sunlight and have sufficient ventilation around the flat panel display to allow cooling. The diagram
below is an example of a stand-mounted panel with proper ventilation.
Use the checklist below to judge possible installation sites.
For specific cautions and safety information, refer to “8.2 Physical Location & Temperature Considerations” and
“8.8 Safety Precautions.”
Sufficient ventilation No danger of power overloads
Safe from excessive vibrations Separate from other IR equipment
Away from air conditioners Protected from hits or shocks
Free of moisture or dampness Distance from heat sources
No danger of splashing water Out of direct sunlight
Route cords and cables safely Away from strong lighting sources
Over
10 cm
(3 15/16
inches)
Over 50 cm
(19 11/16 inches)
Table top stand
(optional)
The distance behind and above the panel
changes depending on your choice of mount.
Consult with your dealer or professional
installer for proper ventilation.
KRP-600M_500M.book Page 15 Monday, June 16, 2008 10:23 AM
To Next Page
Loading...
