Pioneer MVH-290BT User Manual (English)

Other manuals for Pioneer MVH-290BT

Questions and Answers:

I
ivanceJul 27, 2025
Why is there no sound coming from the speakers of my Pioneer MVH-290BT Receiver?
- A
  Alexis SimsJul 27, 2025
  If you are experiencing no sound from the speakers of your Pioneer Receiver, first try changing the source to see if you can hear sounds from at least one of them. If you can hear sounds from a particular source, consider replacing the product or the MBL CMPX MODULE if available. If you cannot hear sounds from any source, check the signal in the input of PowerAMP IC (U4). IN1 U4 11-pin FL IN2 U4 12-pin RL.
C
Christopher HuffmanAug 3, 2025
What to do if there is no sound from BT audio on my Pioneer MVH-290BT?
- R
  rwilliamsonAug 3, 2025
  If your Pioneer Receiver has no sound when using BT audio, verify that the BT device is correctly paired. If incorrectly paired, try pairing the BT device again. If correctly paired but there's still no audio, refer to "No sound from the speakers" for further troubleshooting. If other BT devices also cannot be paired, consider replacing the product or the MBL CMPX MODULE if available. If other BT devices can be paired, the issue is likely with the BT device itself.
C
Christian HebertAug 11, 2025
Why is there no sound from the PreOUT of my Pioneer MVH-290BT?
- J
  Joseph CollinsAug 12, 2025
  If there is no sound from the PreOUT on your Pioneer Receiver, check the impedance between the Ground of PreOUT and the Ground of this product. If the impedance is OPEN, replace the Poly Switch (FU1). If the impedance is SHORT, replace the product or the MBL CMPX MODULE if available. Also, check the power of MAIN BOARD PCB (Connector J9 15-pin: A5V).
R
rachelmartinezAug 18, 2025
How to fix a Pioneer MVH-290BT Receiver that is unable to turn on?
- A
  Aaron JordanAug 19, 2025
  To troubleshoot a Pioneer Receiver that won't power on, begin by checking the 10A blade fuse to see if it has blown. If the fuse is blown, verify the voltage. If the voltage is not normal, replace the product or the MBL CMPX MODULE if available. If you don't find any issues, try replacing the fuse.

Pioneer MVH-290BT Specifications

General

Peak Power Output	50 Watts x 4 Channels
Sub Preamp Outputs	Yes
Bluetooth	Yes
USB Port	Yes
AUX Input	Yes
Display Type	LCD
Equalizer	5-Band Graphic EQ
Remote Control	Yes
iPod Compatibility	Yes
DIN Size	1 DIN
Preamp Voltage	2 volts
Audio Formats Supported	MP3, WMA
Power Output	50W x 4
Dimensions	178mm x 50mm x 159mm