Hew te reute cables
Speed clamps and bead bands are included with this unit
for bunching cables together Orlce components are
connected, follow the following steps to route cables,
* AS viewed from the rear of the display
2
1 Organize cables together using the provided
speed clamps.
Inse_t(1_into an appropriate hole on the _ea_of the
unit, then snap (2} into the back of (1} to fix the clamp,
Speed clamps are designed to be difficult to undo
once in place, Please attach carefully
To attach the speed clamps to the main unit
Connect the speed clamps using the 4 holes marked with
• below, depending on the situation
2 Bunch separated cables together and secure
them with the provided bead bands.
Note
Cables can be routed to the right or left
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward,
In some cases the clamp may have deteriorated ove_
time and may be damaged when *emoved,
<ARE1349 > En
To Next Page
Loading...
