Pioneer PE6000 Series - Group P4: Input Terminals

Description of Function Codes PE6000 User Manual
100
• 8: Communication setting
The output voltage is set by the host computer by means of communication.
The voltage source for V/F separation is set in the same way as the frequency source. For
details, see P0-03. 100.0% of the setting in each mode corresponds to the rated motor voltage. If
the corresponding value is negative, its absolute value is used.
Function
Code
Parameter Name Setting Range Default
P3-15 Voltage rise time of V/F separation 0.0–1000.0s 0.0s
P3-15 indicates the time required for the output voltage to rise from 0 V to the rated motor
voltage shown as t1 in the following figure.
Figure 5-5 Voltage of V/F separation
Group P4: Input Terminals
The PE6000 provides five DI terminals (DI5 can be used for high-speed pulse input) and two
analog input (AI) terminals.
Function
Code
Parameter Name Default Remark
P4-00 DI1 function selection 1: Forward RUN (FWD) Standard
P4-01 DI2 function selection 2: Reverse RUN (REV) Standard
P4-02 DI3 function selection 4: Forward JOG (FJOG) Standard
P4-03 DI4 function selection 9: Fault reset (RESET) Standard
P4-04 DI5 function selection 12: Multi-reference terminal 1 Standard