PE6000 User Manual
Operation, Display and Application Examples
41
the voltage or current and actual setting or feedback is defined by P4-13 to P4-27.
P3-29: AI curve selection
The sampling of AI terminals can be queried in U0-09 to U0-
11. The calculation value is for
internal subsequent calculation and cannot be directly read by the user.
3.12 Use of AO Terminals
The AC drive supports one AO terminal, and AO1 is provided by the control board.
Terminal Output Signal Characteristic
AO1-GND
If J5 is connected to the position with "V" mark, it outputs the signal of
0–10 VDC. If J5 is connected to the position with "I" mark
signal of 0–20mA.
AO1 can be used to indicate the internal running parameters in the analog mode.
The property of indicated parameters can be defined by P5-07 and P5-08.
The designated running parameters can be rectified before output. The rectification feature is
Y = kX + b
, among which "X" indicates the running parameters to be output, and "k" and "b" of
AO1 can be set by P5-10 and P5-11.
up to 5 curves.
Different AIs can
use one curve.
Curve 1: P4-
P4-17
Curve 2: P4-
P4-22
AI1 internal
calculation value
Unit's digit: AI1
Curve selection: 1-5
Ten's digit: AI1
Curve selection: 1-5
AI2 internal
calculation value
Curve 5: A6-
A6-15
Operation, Display and Application Examples
11. The calculation value is for
If J5 is connected to the position with "V" mark, it outputs the signal of
The designated running parameters can be rectified before output. The rectification feature is
, among which "X" indicates the running parameters to be output, and "k" and "b" of
To Next Page
Loading...