Pioneer SC-LX904 - Page 188

188
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Surr Back Left 0.0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
/ , adjust
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with / . To
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Conguration"
- "Speaker Channels" matches the number of
connected channels.
Setting Item Default Value Setting Details
Surround Left 0.0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
/ , adjust
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with / . To
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Conguration"
- "Speaker Channels" matches the number of
connected channels.
Subwoofer 1 0.0 dB After selecting the speaker frequency from between
"31 Hz" and "250 Hz" with the cursors
/ , adjust
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" (0.5dB intervals) with / . To
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• This cannot be selected if "No" is set in
"System Setup" - "Speaker" - "Conguration" -
"Subwoofer".