Pioneer SC-LX904 - Connecting a Pre-Main Amplifier (ZONE 3)

86
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Connecting a Pre-main Amplier (ZONE 3)
You can enjoy 2-ch audio in the separate room (ZONE 3) while performing
playback in the main room (where this unit is located). Use an analog cable to
connect the ZONE 3 PRE/LINE OUT jack of this unit and the LINE IN jack of the
pre-main amplier or power amplier in the separate room. The same source
can be played back in the main room and ZONE 3 simultaneously. Also, different
sources can be played back in both rooms.
• To output audio from an externally connected AV component to ZONE 3, use
an analog audio cable for connection. Note that ZONE 3 output is not possible
with the connection using a HDMI cable, digital coaxial cable, or digital optical
cable.
Setup
• This function can be used when any of the combinations among 2.1 ch, 3.1
ch, 4.1 ch, 5.1 ch, 6.1 ch 7.1 ch, 2.1.2 ch, 3.1.2 ch, 4.1.2 ch, and 5.1.2 ch in
"Speaker combinations" ( p75) is used.
• When connecting the power amplier, set "Multi Zone" - "Zone 3" - "Output
Level" ( p175) to "Variable" on the System Setup menu. If it is not set,
a large volume is output and the power amplier, speakers, etc. may be
damaged.
ZONE B
(LINE OUT)
4K HDR
4K HDR
HDMI OUT
ARC
eARC
USB
5 V 500 mA
a
LINE
IN
a
BD/DVD
Premain Amp.
a Analog audio cable