Need help?Do you have a question about the Pioneer TS-600 and is the answer not in the manual?
General| Brand | Pioneer |
|---|---|
| Model | TS-600 |
| Category | Transceiver |
| Language | English |
Single/double conversion transceiver with built-in VFO covering 50.00-54.00MHz.
Includes a noise blanker to eliminate pulse noise like ignition noise.
Calibrates tuning dial at 100kHz intervals; disables RF input for calibration.
Accurate 'S' meter, functions as tuning meter for FM.
RIT circuit for fine tuning during reception (SSB/CW).
Operates on AC 120/220V or DC 13.8V with built-in DC voltage multiplier.
Guidance on selecting a well-ventilated, dry location for the transceiver.
Instructions for connecting AC and DC power sources, emphasizing safety.
On-off control for the Receiver Incremental Tuning circuit.
Calibrates receive frequencies at 100kHz intervals; stops operation.
Fine adjusts receiving frequency when RIT is ON.
Initial setup and control adjustments for receiving signals.
Procedure for zeroing in on SSB signals using the MAIN dial and beat tone.
Procedures for optimum reception and signal adjustment before transmitting.
Turning BAND/MODE switches and setting STANDBY for CW transmission.
Calibrating the MAIN dial using the 100kHz marker unit.
Calibrating LSB frequency by matching MAIN dial to LSB dial gauge.
Calibrating CW frequency by setting MAIN dial to '0' mark against LSB dial gauge.
Using the semi-synthesizer crystal oscillator for fixed channel operation.
Calibrating FM/AM by carrier frequency and maximum meter deflection.
Using Receiver Incremental Tuning to shift receive frequency.
Operating the TS-600 with external DC 13.8V for mobile use.
Adjusting fixed channel crystal oscillator frequencies using a frequency counter.
To Next Page