To Next PageTo Next Page
Need help?Do you have a question about the Pioneer VSX-C402-S and is the answer not in the manual?
General| Channels | 5.1 |
|---|---|
| Total Harmonic Distortion | 0.09% |
| Frequency Response | 10Hz-100kHz |
| THD | 0.09% |
| Input Sensitivity | 200 mV (line) |
| Output Power | 100W |
| Input Impedance | 47kΩ |
| Power Output | 100W |
Check should be performed for continued protection of customer and service technician.
Electrical/mechanical parts have special safety characteristics.
Details on power output, input sensitivity, impedance, and output level.
Specifications for frequency range, sensitivity, S/N ratio, and distortion.
Block diagram illustrating the audio signal flow.
Block diagrams for video and power supply sections.
Diagram showing all internal component wiring.
Circuit for detecting A/D overload.
Circuit for input attenuation.
Schematic of the FRONT IN Assy.
Schematic of the AMP KAWA Assy.
Schematic of the SUR OUT Assy.
Schematic of the ENCODER Assy.
Schematic of the POWER SW Assy.
Schematic of the FRONT Assy.
Schematic of the D5V Assy.
Schematic of the PRIMARY Assy.
Schematic of the 12V Assy.
Schematic of the VHVL Assy.
PCB layout for SCART-1F and 12V Assy, Side A.
PCB layout for SCART-1F Assy.
PCB layout for 12V Assy.
PCB layout for Mother, DSP KAWA, D5V Assy, Side A.
PCB layout for D5V Assy.
PCB layout for DSP KAWA Assy.
PCB layout for Mother Assy.
PCB layout for Encoder, Front, Power SW, SUR OUT Assys, Side A.
PCB layout for FRONT Assy.
PCB layout for POWER SW Assy.
Details on tuner adjustments.
Information on the unit's protection mechanisms.
Details on automatic speaker detection.
Explanation of specific circuit functionalities.
Guide for diagnosing and resolving common issues.
Steps for troubleshooting DSP problems.
Timing charts for system operations.
Sets remote to receiver mode.
Selects receiver input source.
