Maintenance and Servicing
Procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO PREVENT INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs,
have the problem corrected before further use.
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER EVERY USE:
• loosen the Lock Knob, set to the lowest
torque setting, then tighten the Lock Knob.
• wipe wrench with a clean cloth.
Do not use liquid on the cloth or
immerse wrench in liquid.
3. EVERY 6 MONTHS, have the
Torque Wrench calibrated and
serviced by a qualified technician.
Note: Replacement parts are not available.
3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • 1-888-866-5797
To Previous Page
Loading...
