*EN60436 ā this programme is the test-programme.
(Capacity 12 table settings/ upper basket in low position/ rinse aid setting 6 ( 4
when four setting dispenser)
6.1 Starting of a programme
1. Fill the lower rack first.
2. Pour the dishwasher detergent and the water softener (=dishwasher salt) in the
relevant containers.
3. During operation the appliance must be supplied with water ( full water pressure).
4. Close the door properly while pressing gently. When the door closes properly you
will hear a light KLICK.
5. Press the PROGRAM button to select a programme.
6. Press the OFF button when the programme has ended. Open the door.
6.2 How to change a running programme
You can only change a programme when it has run a short period of time.
Otherwise the detergent has dissolved and the dishwater has been drained.
In such a case you must refill the detergent container.
1. Press the ON/OFF button to cancel the current programme.
2. Switch on the appliance again.
3. Set the new programme.
4. Close the door.