Pkm WA7-E1214 - Water Supply Hose Connection

52
2.4 Connection of the water supply hose
COLD WATER CONNECTION:
 Required water pressure: 30kPA - 1000kPa
1. Ensure that the rubber washer is in the valve
connector (both ends / s. fig on the right).
2. Attach the water inlet hose to the appropriate
water connection (s. fig. on the right).
3. Put the other end of the water inlet hose into a
bucket or into an another suitable container (s. fig
on the right) and open the water tap to flush
foreign substances (e.g. dirt, sand, etc.) out of the
water pipe and of the hose. Check the water
temperature.
4. Ensure that the rubber washer is in the valve
connector. Attach the water inlet hose to the inlet
valve of the washing machine (s. fig. on the right /
1). Tighten the water inlet hose firmly to avoid
leakage (s. fig. on the right / 2).
NOTICE! Do not overtighten the water inlet hose. Overtightening of the
water inlet hose can damage the valves.