Wearing your headset, power it on. The first time
you do, you will be prompted to select your
language from a set of three options. When
completed, you will hear "pairing", go to the
"settings" menu on your phone to connect to your
headset.
SELECT LANGUAGE
1
When the headset indicator lights flashes red
and blueactivate Bluetooth® on your phone and
set it to search for new devices.
• iPhone* Settings > Bluetooth > On
• Android
™
Smartphones* Settings > Wireless &
Networks > Bluetooth: On > Scan for devices
2
If necessary, enter four zeros (0000) for the
passcode or accept the connection.
Once successfully paired, the indicator lights
stops flashing.
GET PAIRED TAKE CONTROL
Answer or end a call
Tap the Call button .
Decline a call
Press the Call button for 2 seconds.
Adjust the volume
Tap the Volume up (+) or down (–) button.
Mute on
During a conversation, simultaneously tap the
Volume (+) and (–) buttons. You will hear “mute
on”, this voice alert will be repeated once. After
that an alert tone repeats every 15 minutes when
mute is on.
Activate voice dial (phone feature)
Press the Call button for 2 seconds, wait for
the phone prompt and then tell the phone to dial
the name of a stored contact.
Change language
Reselect the headset language at any time by
putting your headset into pair mode.
Press the Call button
until the indicator light
flashes red and blue and you hear "pairing, please
select a different language."
Redial
To call your last number dialed, double tap the
Call button
.
The universal-fit eartip has a thin loop that bends
to gently tuck into the contours of either ear. To
adjust the fit, you can rotate the eartip on the
headset or add the optional clip-on earloop.
ADJUST THE FIT
For the best voice pickup, always check that the
headset points toward the corner of your mouth.
Your new headset has enough power to pair and
make a few calls. It takes 2 hours to fully charge
the headset; the indicator light turns solid
blue once charging is complete.
CHARGE