Safety guidelines
The PlasmaCar meets European and
American toy safety standards.
Follow these safety guidelines:
• When unpacking the PlasmaCar, properly dispose of all plastic wrappings.
• Adult supervision is strongly recommended at all times.
• Never use the PlasmaCar near steps, swimming pools, or vehicle traffic.
• Never use the PlasmaCar on a steep slope, or over rough or uneven surfaces.
• To prevent falls, the child should sit leaning slightly forward.
• The maximum load should not exceed 55 kg (120 lbs) on
uneven surfaces, or 100 kg (220 lbs) on smooth surfaces.
Assembly
Included: 1. Body 2. Steering wheel assembly 3.
Front wheel assembly with foam sheath 4a. Right
rear wheel (packed in a blue bag) 4b. Left rear
wheel 5. Steering wheel cap 6. Hex key
Tools required: Rubber mallet, screwdriver or
17mm socket wrench
2
Strike the rear wheels with a rubber mallet to secure them
in place.
Note: To use a steel hammer, place a small block of wood
on the area to be struck.
5
Strike the base of the front wheel assembly with a rubber
mallet. The metal bearing should be seated securely in
the body.
6
Fit the steering wheel into the top of the front wheel
assembly.
Note: Ensure that the bolt is attached to the steering
wheel as shown.
1
Fit the notch on each rear wheel housing into the body.
Push the wheels in at a 45 degree angle. When installed
correctly, the rear wheels flare out from the body.
Warning: The rear wheel housing cannot be removed
once locked into place.
4
Guide the front wheel shaft through the body, into the
foam sheath, and through the hole at the top of the body.
3
Remove the foam sheath from the front wheel assembly.
Choking and suffocation hazard.
Recommended age: 3+
1 2 3
A B
4 5 6
To Previous Page
Loading...
