ASSEMBLY FOR PLASTIMO BOATS WITH INFLATABLE FLOOR
PI270VH and PI310VH
1. Unfold and stretch out the floor onto the bottom of the boat, edging it under the half-inflated tubes and against the
transom. The valve must face upwards.
2. Inflate the floor up to ¾.
3. Finish inflating the boat.
4. Finish inflating the floor.
5. Fully inflate the keel for PI270VH and PI310VH.
ASSEMBLY FOR P180S, P180SF, P200SH, P220SH, P220SL, P240LG, P240SH, P240HH,
P240SL, P260S, P260SL, P270SH and P270SF
Before inflating the boat, slide each slat into a fabric sleeve.
The boat can be rolled up with slats in place, but remove them when cleaning out sand and small stones.
FLOOR ASSEMBLY FOR P240KH, P270KH, P270HH, P310HA, P340HA and P380HA
NOTE : identifying numbers on floor boards must face upwards.
1. Insert floor board No.1 in bow of boat.
2. Insert floor board No.4 in transom of boat.
3. Insert floor board No.2 into floor board No.1.
4. Insert floor board No.3 into floor boards No.2 and 4 and press down until flat.
Slat
Bow board
Transom
Press down
GB
5
37295_03.cdr
25 novembre 2008
To Next Page
Loading...