13
Step 2
Assembling Middle Sections:
IMPORTANT: When assembling, please make sure that all the Reinforcing Brackets of the But-
tresses are located on the dry/outer side of the pool.
• Screw six 1” self-tapping screws into the top openings (leaving the lower openings empty) through
two Top Ledges and two Bottom Channels into one Buttress Post and two Wall Panels to attach a
middle section as illustrated below.
Note: Screws for the Top Ledges should be located only on the outer/dry side of the pool. Before
screwing for easier screwing, please pre-drill all the necessary openings by using a 1/8” drill bit through
the factory pre-drilled ¼” openings.
• Use the holes located on the Top Ledge and Bottom Channel as your guide.
To Next Page
Loading...