To Next Page

To Previous Page

Installation

7.5 Checking the Power Pack Oil Level Access™ EA & Access™ EAB

Before checking the Oil Level, ensure the lift is completely lowered- failure to do so could

cause a false reading- and overfilling with oil WILL cause permanent damage to the pump.

Wipe away any residual oil/ dirt from around the oil filler so that the level of oil can be

correctly seen. If the level has dropped below the 25mm limit then remove the filler cap

and top up slowly with PLS Blue oil ONLY

, when the correct level is achieved then replace

the filler cap. Operate the lift several times and then repeat the checking process.

7.5 Checking the Power Pack Oil Level Access™ EA & Access™ EAB

FLOOR LEVEL

LIFT MUST BE IN FULLY LOWERED POSITION

BEFORE CHECKING OIL LEVEL

ENLARGED VIEW

SHOWING PUMP WITH COVER REMOVED

25MM MAX

Questions and Answers:

Need help?

Do you have a question about the PLS Access EA Series and is the answer not in the manual?

PLS Access EA Series Specifications

General