Why does my PNI OV288 siren continue to ring after installation?
If the siren continues to ring after the main unit is installed and the remote control cannot cancel it, verify that the wires are properly connected, ensure that the main unit's fuse is not burnt, and check if the code between the main unit and the remote is correct.
What to do if the PNI Car Alarm remote does not work?
If the remote for your PNI Car Alarm isn't working, try the following: - Check that the battery is not discharged. - Check if the battery pins are in contact. - Check if the remote control is humid. - Check if the remote control is damaged.
What to do if PNI OV288 central locking does not work?
If the central locking system of your PNI Car Alarm is not functioning, verify that the engines are well installed and ensure that the wires and fuse are installed correctly.
Why does the siren sound right after I set the PNI Car Alarm?
If the siren sounds immediately after arming your PNI Car Alarm, you should: - Check if the shock sensor is in trouble. - Check if the shock sensor is too sensitive. - Check that the wires are properly connected.
How to troubleshoot a PNI OV288 Car Alarm siren that does not work?
If the siren of your PNI Car Alarm is not working, make sure that the siren is properly connected to the main unit and check if the siren is connected to the ground.
Explains how to activate the car alarm system using the remote control.
Details how to deactivate the car alarm system using the remote control.
Describes the procedure for arming the system without audible alerts.
Outlines steps to disarm the system without a remote control.
Provides instructions on how to add new remote controls to the system.
Guides on shock sensor installation and sensitivity adjustment.
Addresses common problems with remote control, siren, and central locking.
General| Operating Frequency | 433.92 MHz |
|---|---|
| Power Supply | 12V DC |
| Immobilizer | Yes |
| Anti-Hijack | Yes |
| Compatibility | Universal |
| Central Locking | Yes |
| Current Consumption (Alarm) | 500 mA |
To Next Page