Pocket NC V2 - Real Time Delay Error

-3.45 to 0.10
inches*
d. The A limits are
-25 to 135
degrees
e. The B limits are
-9999 to 9999
degrees
*you have to add the tool
length offset to the Z axis
value
5. Adjust the location of the
part/stock so that it is
within the Pocket NC’s
work envelope
6. Decrease the retract
height on the toolpaths if
the part is close to the
limits of the Pocket NC’s
travel.
7. Oversized parts may be
able to be fixtured and
cut one side at a time
instead of all in one
program.
14 Unexpected Real Time
Delay on RT Thread 1
This error means that there
has been a delay in the
Beaglebones processor.
1. This error can be caused
by a temporarily dropped
connection between the
computer and the Pocket
NC mill or by a program
that is so large and
complicated that the
Beaglebone’s processor
cannot keep up.
2. Check that the
connection between the
computer and the
machine is good.
3. Try slowing down the
feed rate or reducing the
file size of the G code file
8