PocketWizard Utility
Some settings require the PocketWizard Utility software and your ControlTL radio
connected to a computer via the Mini-USB port. Download the Utility at:
www.PocketWizard.com/support
FlexTT5
®
Receiver settings that affect the use of an AC9:
PowerTracking Tab
AC9 Flash Exposure Compensation: Use this control to adjust the FEC of the ash directly connected to the AC9
in this receiving radio’s hot shoe. This setting is cumulative with other FEC values set in the system. See the FEC
NOTE for more information. FEC can be adjusted in +/- 3 stops. Default = 0.0
This setting can be used as a simple FEC control for an individual ash, or it can be used to set ashes on the same
zone to different power outputs or to balance them. For example, you could set it to -1.0 to make an AlienBees B800
match the power of a B400.
This control can also be used to adjust where the PowerTracking center point aligns with your camera’s FEC control.
See the Camera FEC Range section for more information.
Sleep Tab
Local Flash Sleep Mode/Delay: The modeling light will turn off after the set time if no triggers are received.
Uncheck the box to have the modeling light stay on. Default = Enabled at 600 seconds (10 minutes)
The remaining settings on the Sleep Tab do not apply to the AC9.
To Next Page
Loading...