Center on Aperture Only: PowerTracking will only work with aperture changes. Set the desired aperture using
the Aperture Center-On control. ISO changes will be ignored for PowerTracking for Nikon cameras, and FEC/ISO
changes for Canon cameras.
Center on ISO Only: PowerTracking will only work with ISO changes for Nikon cameras and FEC/ISO changes
for Canon cameras. Set the desired ISO using the ISO Center-On control. Aperture changes will be
ignored for PowerTracking.
No Change (trigger only): Turns off PowerTracking and the Power Dials on the AC3 will not adjust the power
output of your remote ash. Use this setting if another photographer is controlling the ash’s manual
power output, like when sharing ashes with another photographer and you want to use the exact same manual
ash output power.
AC9 Flash Exposure Compensation: This control is only for receiving FlexTT5 radios with an AC9 AlienBees
Adapter in the hot shoe. Adjusting this setting on a transmitting FlexTT5 will have no affect on your ashes. See the
PocketWizard Utility FlexTT5 Receiver settings sections for how to use this control on a receiving FlexTT5.
For other PocketWizard
®
Utility settings, refer to the documentation for the MiniTT1, FlexTT5, AC3 ZoneController,
PowerST4 for Elinchrom, or other ControlTL radios or accessories.
Temperature
Operating Temperature: Above -15° C (5° F) and below 50° C (120° F)
Storage Temperature: Above -30° C (-22° F) and below 85° C (185° F)
To Next Page
Loading...