27
The food is not frozen
enough.
Temperature is not properly
adjusted.
Look in the initial Temperature
Setting section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Turn the temperature regulation to a
colder setting temporarily.
The appliance is near a heat source.
Look in the installation location
section.
Heavy build up of frost
on the door seal.
Door seal is not air tight.
Carefully warm the leaking sections
of the door seal with a hair dryer (on
a cool setting). At the same time
shape the warmed door seal by hand
so that it sits correctly.
Unusual noises
Appliance is not level. Re-adjust the feet.
The appliance is touching the wall or
other objects.
Move the appliance slightly.
A component, e.g. a pipe, on the rear
of the appliance is touching another
part of the appliance or the wall.
If necessary, carefully bend the
component out of the way.
Water on the floor Water drain hole is blocked. See the Cleaning and Care section.
Side panels are hot.
It’s normal. Heat exchange parts are
in the sides.
Use gloves to touch sides if needed.
If t
he malfunction shows again, contact the Service Center.
This data is to help you quickly and correctly. Write the necessary data here,
refer to the rating plate.
To Next Page
Loading...
