Need help?Do you have a question about the Polargos EASY WAY202 and is the answer not in the manual?
Provides contact information for technical support and assistance with the gate system.
Essential safety guidelines for operating and installing the automatic gate system.
Critical safety measures for handling and storing batteries.
Instructions for component disposal and regulatory compliance.
Routine checks and warnings for safe system operation.
Safe handling of batteries and disposal of worn-out equipment.
Identification of hazardous zones and preventative measures.
Safety measures for impact and crushing hazards.
Preventative measures for hand injuries.
Safety requirements for impact zones.
Precautions against confinement and crushing risks.
Guidelines to avoid foot injuries.
Lists detailed technical specifications and performance data.
Physical dimensions and maximum weight capacity for gate leaves.
Recommended and maximum allowable opening angles.
Physical dimensions of the drive unit and control module.
Explanation of the opening stop mechanism's function.
Inspecting the gate's condition before assembly.
Checks for gate posts prior to installation.
Tools required for correct system assembly.
Initial wiring setup and conductor requirements.
Electrical supply standards and protection needed.
Steps for connector preparation with 70x70 steel posts.
Procedures for connector preparation with concrete posts.
Steps for preparing gate leaves for automation.
Instructions for securely attaching gate fasteners.
Mounting the drive unit and performing final checks.
Assembly and locking procedure for gate leaf yokes.
Positioning and securely mounting the electric control box.
Connecting gate actuators and antenna.
Connecting the system to the main electrical supply.
Recommended placement for the electric control box.
Mounting the box and installing electronic components.
Connecting the antenna for optimal signal reception.
Connecting gate actuators to control module terminals.
Preparing the power cable, including conductor lengths.
Connecting ground, phase, and neutral conductors correctly.
Connecting main power supply to terminals.
Securing the cable gland after wiring.
Reference for understanding symbols.
Guides on programming remote controls.
Describes different remote control operating modes.
Reminder to program remote controls before use.
Instructions for powering up the system.
Teaching the system gate movement parameters.
Managing the system's power-saving stand-by mode.
Performing full gate opening and closing.
How the system detects and reacts to obstacles.
Highlights the importance of user training for safe operation.
Functionality for partial gate opening for pedestrians.
Step-by-step guide to activate the pedestrian passage mode.
Explains the automatic closing feature and its parameters.
Instructions on how to switch on the automatic closing feature.
Procedure to turn off the automatic closing feature.
Identifies compatible remote control types.
Methods for programming 2-button remotes for various functions.
Details programming methods for 4-button remotes.
How to use a 3-button remote control for basic gate operations.
Step-by-step guide to add 2 or 4-button remote controls.
Instructions for adding a 3-button remote control.
Process of removing programmed remote controls from the system.
Role of photocells in obstacle detection and gate control.
Optimal placement of photocell sensors for effective operation.
Installing photocells and their operation during gate movement.
Function and connection of the optional orange warning light.
Purpose and installation of an optional rechargeable battery for backup power.
Benefits and connection of an optional independent antenna for extended range.
Connecting an optional video intercom system to the gate.
Wiring an optional key switch for gate control.
Description of the optional zone lighting feature and its activation.
Connecting and using the optional solar energy supply system.
How to replace the battery in the remote control unit.
When and how to reset the system's settings to default.
Resetting settings and clearing saved remote control data.
Procedures for manually locking and unlocking the gate drives.
Identifying and resolving common system faults and errors.
To Next Page
General