Steady
Ready to jump-start.
Steady
Standby. Cables are plugged into
the jump-starter and are now ready
to be connected to the battery.
Flashing
1. Cables are hooked up properly
but have not been used for
60 seconds. Please press
reset button to be ready.
2. Reverse Polarity Protection:
clamps are attached to the
incorrect battery terminals.
Please connect terminals
and press reset button.
3. Short Circuit Protection:
Black and red clamps are
touching. Please connect
the correct terminals and
press reset button.
Knowing
the Cables
To Next Page
Loading...
Need help?
General