ENGINE
2.19
ENGINE ASSEMBLY
5. Make sure oil pump area is clean. Install oil pump
and torque to specification. Install new stator
gasket.
6. Install stator. Torque bolts to specification.
7. Inspect flywheel key for damage. Replace if
necessary. Install flywheel and torque to
specification.
8. Install driven clutch shaft components and shaft
assembly.
Oil Pump Bolt Torque:
43 in.lbs. (5 Nm)
Stator Mounting Bolt Torque:
84 in.lbs. (9.5 Nm)
Flywheel Nut Torque:
25 ft.lbs. (34 Nm)
To Next Page
Loading...
